(DV-2211) Table Settings

Owned by SNP
Nov 25, 2022
2 min read
Table RowCount Precise Compare
  • If this option is set to 'X' RowCount columns in Table variant images will be compared without the use of acceptable threshold differences.
Table Decimal Places Precision
  • The number of decimal places to be displayed/compared in the Table testing scenario. Possible values: 0 to 14.
Max. disp. Table row count
  • Maximum lines to be displayed at once in Table testing scenario 'Display results' steps
Max. Table image row size
  • The maximum number of rows that will be saved during the creation of a Table image. If this threshold is reached no more rows are saved and the image creation ends with an error. This is a safety check to prevent eating up too many resources with non-defined variants. The default value is 500.000 rows. Max. allowed value is 20.000.000 rows, anything greater will be overwritten by default value during execution.
Max. Table image size (in Megabytes)
  • The maximum image size that can be used during the creation of a Table image. If this threshold is reached or exceeded no more data will be saved and the image creation will end with an error. This is a safety check to prevent eating up too many resources. The default value is 3800MB. The maximum allowed value is 3800MB, anything beyond this value will be overwritten by default value during execution.
Table Compare Threshold
  • The threshold value for the Table output comparison. If a difference between the Before/After image values is smaller than this threshold then the comparison is evaluated as correct. Possible values are float values greater than 0.
Table Relative Threshold
  • The threshold value for Table output comparison. If the difference between Before the After image values is smaller than this threshold, the comparison is evaluated as correct. Possible values are float values greater than 0.
Table Own Aggregation
  • If this option is set to 'X' SNP Validate uses its own aggregation instead of DB aggregation during image creation. It is turned off by default and automatically turns on when processing a cluster table. Should only be turned on manually when DB aggregation fails, as it is slower.
Filter enh. error behavior
  • This setting can have two states: 'FINISH_ERROR' or 'FINISH_WARNING'. It is used as a check for how to display a message when something goes wrong with adjusting the table filter.
Delta value field in sour. tab
  • This setting holds a field name that will be added to the delta filter. Delta filter is used when additional table variant filter adjustment is needed.
Delta table name
  • Holds the name of the delta table.
Delta logic meta table
  • This setting holds the name of the metatable for mapping purposes.
Use Hyperledger for snapshots
  • If this option is set to 'X', hyperledger will be used for snapshots.
Use ORDER BY for selection
  • If this option is set to 'X', ORDER BY will be used on selecting data.