(1908) InfoPackage (3x) Load Including Offloaded Data

Owned by SNP
Oct 31, 2018
1 min read

It is possible to transfer already offloaded data from a DataProvider to an InfoProvider through the InfoPackage load. In this kind of load already offloaded data of a DataProvider is appended to other data and stored in the target InfoProvider.

Requirements for the InfoPackage load are almost the same as the requirements for the DTP load except that the following three requirements contain these changes:

  • SAP HANA Execution

SAP HANA Execution isn't available for 3x load, therefore this requirement isn't relevant.

  • Parallel Extraction

The Parallel Extraction isn't as well available for the 3x load.

  • The Extraction Mode is set to "Full"

For 3x loads you should set the Extraction Mode to 'Full' as by the DTP loads, but you perform this on the Update tab.

Full extraction mode within 3x load

For the remaining requirements, please see the chapter (1908) Data Transfer Process (DTP) Including Offloaded Data.

Log display

The job log of a 3x load with information about offloaded data can be displayed as follows:

  1. Go to the RSA1, select the specific InfoProvider.
  2. Then right-click Manage, click on the Monitor icon.
                                                                                                                                      Displaying Monitor from RSA1
  3. Copy its Request ID.

         Request ID of the 3x load in the Monitor InfoPackage

  4. Go to SM37. Fill the Job Name with the copied Request ID after the preceding asterisk sign. Enter the asterisk sign into User Name.
  5. Click Execute.

Selecting a job using the Request ID

       6. Click Job log to display the log.




Displaying a Job log


Below is an example of a job log from the 3x load. The information about the offloaded data can be found under the Message ID /DVD/OFF_LOG.     

Job log from the 3x load