Versions Compared

Old Version 2

changes.mady.by.user Veronika Hunorova (Unlicensed)

Saved on

compared with

New Version Current

changes.mady.by.user Peter Bucka

Saved on

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

  • All the key figures and appropriate unit/currency characteristics are always returned in the ListCube output. There is an exception for Key Figures with the aggregation function NOP. When the 'Use DB Aggregation' setting is active, Key Figures of this type are not returned in the output.
  • All characteristics of the InfoProvider (from Validate version 1.4.2 navigational attributes are also supported) are checked for compliance with the specified characteristic selection. If yes then they are returned in ListCube output.

  • From Datavard Validate version 1711 order of characteristics for output is important. Same order will be used for storing data of actual image. Make sure before/after images have same order/number of key characteristics otherwise data compare will not be successfull. 

    Note

    Order of units cannot be changed in current version and is defined by their position in InfoProvider. Before installing version 1711 on your system customer needs to finish all testing as data images created on previous versions for same variant are not compatibile with data images created with version > 1711. 


  • Reference Time Point setting usable only for InfoCubes, MultiProviders, certain types of ADSOs and Composite Providers. For other InfoProviders this setting is ignored, as it is not possible to use the filtering on 0REQUID/0REQTSN field in the ListCube. For InfoCubes this setting influences only the read data from the Fact table. For ADSOs read of data from Inbound table. Please note that in MultiProvider Cubes, this setting will affect the InfoCubes below but not the DSOs as their data have 0REQUID set to value ‘0’. t to value '0'.
Warning
If a different after image variant is specified for the ListCube variant some restrictions are then applied in terms of comparing results of the before/after image. The used ListCube variants must have exactly the same number, type, and name of characteristics and units of the InfoObjects selected for output. When so, Validate is able to compare the before/after image, if some Key Figures are missing in one of the variants in comparison to another variant then these columns are ignored during the comparison.

...